Skip to main content

On-Site Network Reference

This page collects the network addresses, management page entries and connection topology needed for on-site commissioning. Print it or bookmark it for quick reference.

Download the printable version (PDF, single A4 page)

On-Site IP Address Reference​

ItemDefault address / formatOn-site valuePurpose
TeleSuit Wi-FiIO_5G_***** / IO_2.4G_*****; some older devices use Y2_5G_****______Device network that the VR and computer connect to
Wi-Fi passwordminnanoIO2023______Connect to the TeleSuit Wi-Fi
TeleSuit main control IP10.42.0.2______Motion capture suit, teleoperation main control
TeleSuit management pagehttp://10.42.0.2:8686______Main control management, trajectory replay, device shutdown
TeleSuit upgrade pagehttp://10.42.0.2:5000______Device upgrade, check internet status
TeleBox IP10.42.0.3; 10.42.0.4 for the device port in collection mode (wireless)______Simulation and device management
VUER simulation pagehttp://10.42.0.3:8012______OpenLoong simulation
TeleBox management pagehttp://10.42.0.3:7876______Configuration, data management, mode switching, device shutdown
TeleBox upgrade pagehttp://10.42.0.3:5000______Device upgrade, check internet status
Router management page10.42.0.1 (login password admin123)______LAN gateway + wireless relay switch
Robot IPDetermined by the project______Physical robot connection
Robot control computer IPDetermined by the project______Robot control side
DNS (special configuration only)8.8.8.8, 4.4.4.4______Manual wireless connection configuration

Quick experience phase:

VR headset ──Wi-Fi──┐
├── TeleSuit network ── TeleBox ── 8012 VUER simulation
Laptop ────Wi-Fi────┘

After connecting a physical robot:

VR headset ──Wi-Fi/wired── TeleSuit ── TeleBox ── robot control computer / robot
Computer ───Wi-Fi/wired───┘

During the simulation phase the computer can use Wi-Fi; whether to switch to a wired connection for later physical robot commissioning should follow the project's network topology and IP address table.